EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

EB5BZM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB5BZM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1762773369	0 Count	166 Count
1762771264	7 Count	1045 Count
1762769160	6 Count	890 Count
1762767055	5 Count	732 Count
1762764950	4 Count	566 Count
1762762845	3 Count	448 Count
1762760741	2 Count	370 Count
1762758636	1 Count	279 Count
1762756531	0 Count	144 Count
1762754427	10 Count	1113 Count
1762752322	9 Count	944 Count
1762750217	8 Count	782 Count
1762748112	7 Count	609 Count
1762746008	5 Count	453 Count
1762743903	2 Count	305 Count
1762741798	1 Count	169 Count
1762739693	14 Count	1155 Count
1762737589	11 Count	985 Count
1762735484	9 Count	825 Count
1762733379	7 Count	654 Count
1762731274	5 Count	467 Count
1762729170	3 Count	288 Count
1762729164	2 Count	288 Count
1762729154	1 Count	288 Count
1762727854	0 Count	182 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)