EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2OSA Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2OSA. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1790088297	26 Count	469 Count	22 Count
1790086496	24 Count	425 Count	21 Count
1790084695	22 Count	372 Count	20 Count
1790082894	20 Count	296 Count	19 Count
1790081094	12 Count	137 Count	12 Count
1790079293	55 Count	1076 Count	36 Count
1790077492	50 Count	959 Count	32 Count
1790075692	48 Count	848 Count	31 Count
1790073891	46 Count	743 Count	30 Count
1790072090	44 Count	634 Count	29 Count
1790070290	42 Count	529 Count	28 Count
1790068489	40 Count	447 Count	27 Count
1790066696	34 Count	390 Count	26 Count
1790064895	32 Count	345 Count	25 Count
1790063094	30 Count	303 Count	24 Count
1790061293	28 Count	261 Count	23 Count
1790059493	26 Count	207 Count	22 Count
1790057692	24 Count	165 Count	21 Count
1790055891	19 Count	112 Count	17 Count
1790054091	17 Count	76 Count	16 Count
1790052290	15 Count	49 Count	15 Count
1790050489	120 Count	1064 Count	75 Count
1790048688	109 Count	982 Count	65 Count
1790046888	107 Count	945 Count	64 Count
1790045095	101 Count	922 Count	63 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)