EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

EA4ATS-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4ATS-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1785062475	9 Count	541 Count
1785060672	8 Count	506 Count
1785058906	7 Count	462 Count
1785057103	6 Count	390 Count
1785055299	5 Count	316 Count
1785053496	4 Count	280 Count
1785051693	3 Count	238 Count
1785049890	2 Count	189 Count
1785048087	1 Count	135 Count
1785046283	0 Count	72 Count
1785044480	22 Count	1045 Count
1785042677	21 Count	993 Count
1785040874	20 Count	947 Count
1785039071	19 Count	914 Count
1785037305	18 Count	868 Count
1785035502	17 Count	817 Count
1785033699	16 Count	746 Count
1785031896	15 Count	698 Count
1785030092	14 Count	661 Count
1785028289	13 Count	626 Count
1785026486	12 Count	593 Count
1785024683	11 Count	526 Count
1785022880	10 Count	476 Count
1785021077	9 Count	440 Count
1785019274	8 Count	410 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)