EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9IWE-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9IWE-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1791537561	1 Count	432 Count
1791535760	0 Count	214 Count
1791533959	14 Count	1231 Count
1791532158	12 Count	972 Count
1791530360	8 Count	772 Count
1791528560	7 Count	640 Count
1791526759	6 Count	500 Count
1791524958	4 Count	294 Count
1791523159	0 Count	151 Count
1791521359	15 Count	1091 Count
1791519558	14 Count	939 Count
1791517757	12 Count	824 Count
1791515959	8 Count	690 Count
1791514158	7 Count	545 Count
1791512357	6 Count	398 Count
1791510556	4 Count	257 Count
1791508758	0 Count	116 Count
1791506957	15 Count	1027 Count
1791505157	14 Count	901 Count
1791503356	12 Count	758 Count
1791501558	8 Count	629 Count
1791499757	7 Count	503 Count
1791497956	6 Count	359 Count
1791496155	4 Count	226 Count
1791494357	0 Count	117 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)