EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP6RGZ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6RGZ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1766724210	114 Count	213 Count
1766722409	113 Count	211 Count
1766720608	112 Count	209 Count
1766718808	111 Count	207 Count
1766717007	110 Count	205 Count
1766715206	109 Count	203 Count
1766713405	108 Count	201 Count
1766711604	107 Count	199 Count
1766709804	106 Count	197 Count
1766708003	105 Count	195 Count
1766706202	104 Count	193 Count
1766704401	103 Count	192 Count
1766702608	102 Count	191 Count
1766700807	101 Count	189 Count
1766699006	100 Count	188 Count
1766697205	99 Count	186 Count
1766695405	98 Count	184 Count
1766693604	97 Count	182 Count
1766691803	96 Count	180 Count
1766681008	90 Count	170 Count
1766679207	89 Count	168 Count
1766677406	88 Count	166 Count
1766675606	87 Count	164 Count
1766673805	86 Count	163 Count
1766672004	85 Count	161 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)