EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F5MIW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5MIW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1791455982	52 Count	264 Count	38 Count
1791452378	51 Count	247 Count	38 Count
1791448773	50 Count	229 Count	38 Count
1791445201	49 Count	213 Count	38 Count
1791441597	48 Count	197 Count	38 Count
1791437993	47 Count	183 Count	38 Count
1791434388	44 Count	168 Count	36 Count
1791430784	39 Count	150 Count	32 Count
1791427180	34 Count	130 Count	28 Count
1791423600	29 Count	110 Count	24 Count
1791419996	24 Count	88 Count	20 Count
1791416392	19 Count	71 Count	16 Count
1791412788	14 Count	51 Count	12 Count
1791409183	9 Count	34 Count	8 Count
1791405579	4 Count	17 Count	4 Count
1791401993	180 Count	1012 Count	143 Count
1791398389	175 Count	995 Count	139 Count
1791394784	162 Count	926 Count	127 Count
1791391180	161 Count	907 Count	127 Count
1791387575	150 Count	858 Count	117 Count
1791383971	115 Count	782 Count	83 Count
1791380392	102 Count	747 Count	71 Count
1791376787	101 Count	730 Count	71 Count
1791373183	94 Count	688 Count	65 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)