EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2OSA-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2OSA-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1790086757	176 Count	715 Count	0 Count
1790085857	172 Count	705 Count	0 Count
1790084956	163 Count	677 Count	0 Count
1790084055	156 Count	639 Count	0 Count
1790083154	146 Count	600 Count	0 Count
1790082253	134 Count	570 Count	0 Count
1790081352	127 Count	542 Count	0 Count
1790080452	118 Count	508 Count	0 Count
1790079551	109 Count	479 Count	0 Count
1790078650	100 Count	450 Count	0 Count
1790077749	94 Count	419 Count	0 Count
1790076848	85 Count	387 Count	0 Count
1790075947	79 Count	349 Count	0 Count
1790075067	73 Count	316 Count	0 Count
1790074167	65 Count	281 Count	0 Count
1790073266	57 Count	252 Count	0 Count
1790072365	49 Count	218 Count	0 Count
1790071464	44 Count	184 Count	0 Count
1790070563	38 Count	150 Count	0 Count
1790069662	32 Count	113 Count	0 Count
1790068761	26 Count	78 Count	0 Count
1790067860	22 Count	44 Count	0 Count
1790066959	14 Count	29 Count	0 Count
1790066059	8 Count	15 Count	0 Count
1790065158	1002 Count	129 Count	113 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)