EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F4FWW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4FWW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1771576874	169 Count	44 Count	42 Count
1771575074	168 Count	44 Count	42 Count
1771573272	167 Count	44 Count	42 Count
1771569682	165 Count	44 Count	42 Count
1771567881	164 Count	44 Count	42 Count
1771566080	163 Count	44 Count	42 Count
1771560678	160 Count	44 Count	42 Count
1771558877	159 Count	44 Count	42 Count
1771557076	158 Count	44 Count	42 Count
1771555275	157 Count	44 Count	42 Count
1771553475	156 Count	44 Count	42 Count
1771551674	155 Count	44 Count	42 Count
1771549873	154 Count	44 Count	42 Count
1771548078	153 Count	44 Count	42 Count
1771546278	152 Count	44 Count	42 Count
1771542676	150 Count	44 Count	42 Count
1771540875	149 Count	44 Count	42 Count
1771539075	148 Count	44 Count	42 Count
1771537274	147 Count	44 Count	42 Count
1771535473	146 Count	44 Count	42 Count
1771533673	145 Count	44 Count	42 Count
1771531872	144 Count	44 Count	42 Count
1771530071	143 Count	44 Count	42 Count
1771528270	142 Count	44 Count	42 Count
1771526477	141 Count	44 Count	42 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)