EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

EB2BRA-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB2BRA-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1787548710	7 Count	258 Count
1787546907	6 Count	235 Count
1787545103	5 Count	199 Count
1787543300	4 Count	175 Count
1787541497	3 Count	149 Count
1787539693	2 Count	115 Count
1787537931	1 Count	75 Count
1787536126	0 Count	41 Count
1787534323	27 Count	1003 Count
1787532520	26 Count	971 Count
1787530716	25 Count	927 Count
1787528913	24 Count	892 Count
1787527109	23 Count	851 Count
1787525306	22 Count	821 Count
1787523503	21 Count	792 Count
1787521699	20 Count	761 Count
1787519896	19 Count	727 Count
1787518092	18 Count	701 Count
1787516329	17 Count	662 Count
1787514525	16 Count	623 Count
1787512722	15 Count	598 Count
1787510918	14 Count	565 Count
1787509115	13 Count	536 Count
1787507312	12 Count	504 Count
1787505508	11 Count	467 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)