EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

MB7USU-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MB7USU-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1783298711	146 Count	219 Count	110 Count
1783296910	142 Count	214 Count	107 Count
1783295109	138 Count	209 Count	104 Count
1783293308	134 Count	204 Count	101 Count
1783291508	130 Count	199 Count	98 Count
1783289707	125 Count	193 Count	94 Count
1783287906	121 Count	189 Count	91 Count
1783286106	117 Count	184 Count	88 Count
1783284314	109 Count	178 Count	84 Count
1783282514	105 Count	174 Count	81 Count
1783280713	100 Count	168 Count	77 Count
1783278912	96 Count	163 Count	74 Count
1783277112	92 Count	158 Count	71 Count
1783275311	88 Count	153 Count	68 Count
1783273510	84 Count	148 Count	65 Count
1783271709	79 Count	143 Count	61 Count
1783269908	75 Count	138 Count	58 Count
1783268107	71 Count	133 Count	55 Count
1783266307	67 Count	128 Count	52 Count
1783264506	63 Count	123 Count	49 Count
1783262714	58 Count	117 Count	45 Count
1783260913	54 Count	112 Count	42 Count
1783259112	50 Count	107 Count	39 Count
1783257312	46 Count	102 Count	36 Count
1783255511	42 Count	97 Count	33 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)