EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ2CPA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2CPA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1783295054	38 Count	442 Count
1783293253	37 Count	434 Count
1783291453	36 Count	426 Count
1783289652	35 Count	418 Count
1783287851	34 Count	410 Count
1783286051	33 Count	402 Count
1783284250	32 Count	394 Count
1783282449	31 Count	386 Count
1783280649	30 Count	378 Count
1783278848	29 Count	370 Count
1783277053	28 Count	362 Count
1783275253	27 Count	354 Count
1783273452	26 Count	346 Count
1783271651	25 Count	338 Count
1783269851	24 Count	330 Count
1783268050	23 Count	322 Count
1783266249	22 Count	314 Count
1783264449	21 Count	301 Count
1783262648	20 Count	277 Count
1783260847	19 Count	259 Count
1783259047	18 Count	243 Count
1783257246	17 Count	229 Count
1783255452	16 Count	215 Count
1783253652	15 Count	203 Count
1783251851	14 Count	191 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)