EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

EA4ATS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4ATS-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1783291045	13 Count	839 Count
1783289242	12 Count	787 Count
1783287438	11 Count	734 Count
1783285635	10 Count	677 Count
1783283831	9 Count	623 Count
1783282028	8 Count	571 Count
1783280225	7 Count	507 Count
1783278454	6 Count	442 Count
1783276650	5 Count	365 Count
1783274847	4 Count	315 Count
1783273044	3 Count	262 Count
1783271240	2 Count	216 Count
1783269437	1 Count	163 Count
1783267634	0 Count	82 Count
1783265830	20 Count	1059 Count
1783264027	19 Count	1000 Count
1783262224	18 Count	945 Count
1783260453	17 Count	891 Count
1783258650	16 Count	840 Count
1783256846	15 Count	799 Count
1783255043	14 Count	746 Count
1783253240	13 Count	694 Count
1783251436	12 Count	654 Count
1783249633	11 Count	604 Count
1783247830	10 Count	550 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)