EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP8AA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8AA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1790089092	857 Count	965 Count	709 Count
1790086940	852 Count	965 Count	709 Count
1790084119	810 Count	896 Count	673 Count
1790081064	770 Count	848 Count	639 Count
1790079644	765 Count	848 Count	639 Count
1790079033	760 Count	848 Count	639 Count
1790077226	740 Count	815 Count	620 Count
1790075419	705 Count	773 Count	586 Count
1790073613	671 Count	729 Count	553 Count
1790071808	652 Count	695 Count	535 Count
1790070418	647 Count	695 Count	535 Count
1790068839	642 Count	695 Count	535 Count
1790065345	632 Count	695 Count	535 Count
1790063934	627 Count	695 Count	535 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)