EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F6JON-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F6JON-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1771591356	190 Count	213 Count	88 Count
1771590451	157 Count	169 Count	66 Count
1771589546	136 Count	141 Count	56 Count
1771588641	104 Count	103 Count	43 Count
1771587736	35 Count	55 Count	17 Count
1771586831	14 Count	30 Count	11 Count
1771585926	692 Count	1018 Count	602 Count
1771585018	675 Count	993 Count	586 Count
1771584113	666 Count	976 Count	578 Count
1771583209	641 Count	945 Count	557 Count
1771582301	622 Count	914 Count	541 Count
1771581396	603 Count	877 Count	523 Count
1771580491	594 Count	862 Count	515 Count
1771579586	580 Count	842 Count	502 Count
1771578681	552 Count	800 Count	475 Count
1771577776	539 Count	782 Count	463 Count
1771576871	528 Count	767 Count	453 Count
1771575966	517 Count	750 Count	443 Count
1771575062	508 Count	738 Count	435 Count
1771574157	497 Count	722 Count	425 Count
1771573381	480 Count	696 Count	409 Count
1771572476	464 Count	671 Count	396 Count
1771571571	450 Count	655 Count	389 Count
1771570667	437 Count	640 Count	382 Count
1771569762	423 Count	626 Count	374 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)