EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP5XTF-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5XTF-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1779390446	783 Count	478 Count	389 Count
1779388646	782 Count	478 Count	389 Count
1779386845	781 Count	478 Count	389 Count
1779385044	780 Count	478 Count	389 Count
1779383244	774 Count	471 Count	384 Count
1779381443	773 Count	470 Count	384 Count
1779379648	772 Count	470 Count	384 Count
1779377847	771 Count	469 Count	384 Count
1779376046	770 Count	469 Count	384 Count
1779374246	769 Count	469 Count	384 Count
1779372445	766 Count	467 Count	382 Count
1779370645	765 Count	467 Count	382 Count
1779368844	764 Count	467 Count	382 Count
1779367043	763 Count	467 Count	382 Count
1779365243	762 Count	467 Count	382 Count
1779363442	761 Count	467 Count	382 Count
1779361642	760 Count	466 Count	382 Count
1779359841	759 Count	466 Count	382 Count
1779358049	758 Count	465 Count	382 Count
1779356248	752 Count	460 Count	377 Count
1779354447	751 Count	460 Count	377 Count
1779352647	750 Count	460 Count	377 Count
1779350846	749 Count	460 Count	377 Count
1779349046	748 Count	460 Count	377 Count
1779347245	746 Count	459 Count	376 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)