EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9LJE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9LJE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1779601065	97 Count	89 Count	89 Count
1779599264	86 Count	79 Count	79 Count
1779597464	76 Count	70 Count	70 Count
1779595668	66 Count	61 Count	61 Count
1779593868	55 Count	51 Count	51 Count
1779592067	44 Count	41 Count	41 Count
1779590266	32 Count	30 Count	30 Count
1779588466	21 Count	20 Count	20 Count
1779586665	10 Count	10 Count	10 Count
1779584864	1005 Count	963 Count	920 Count
1779583064	994 Count	953 Count	910 Count
1779581263	983 Count	943 Count	900 Count
1779579462	972 Count	933 Count	890 Count
1779577662	961 Count	923 Count	880 Count
1779575861	950 Count	913 Count	870 Count
1779566839	939 Count	903 Count	860 Count
1779565038	929 Count	894 Count	851 Count
1779563238	918 Count	884 Count	841 Count
1779561437	907 Count	874 Count	831 Count
1779559636	897 Count	865 Count	822 Count
1779557835	886 Count	855 Count	812 Count
1779556035	875 Count	845 Count	802 Count
1779554234	864 Count	835 Count	792 Count
1779552433	853 Count	825 Count	782 Count
1779550633	842 Count	815 Count	772 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)