EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP5UID-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-4. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1765856813	19 Count	810 Count
1765855011	18 Count	760 Count
1765853210	17 Count	725 Count
1765851409	16 Count	676 Count
1765849611	15 Count	647 Count
1765847810	14 Count	605 Count
1765846008	13 Count	561 Count
1765844207	12 Count	519 Count
1765842411	11 Count	475 Count
1765840610	10 Count	435 Count
1765838809	9 Count	391 Count
1765837007	8 Count	349 Count
1765835211	7 Count	307 Count
1765833409	6 Count	267 Count
1765831608	5 Count	229 Count
1765829808	4 Count	201 Count
1765828010	3 Count	157 Count
1765826209	2 Count	116 Count
1765824408	1 Count	54 Count
1765822606	0 Count	0 Count
1765820810	13 Count	965 Count
1765819009	12 Count	913 Count
1765817207	11 Count	780 Count
1765815406	10 Count	727 Count
1765813610	9 Count	688 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)