EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9LJE-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9LJE-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1762815356	240 Count	824 Count	200 Count
1762813555	237 Count	818 Count	198 Count
1762811755	233 Count	798 Count	195 Count
1762809954	231 Count	788 Count	194 Count
1762808152	230 Count	785 Count	194 Count
1762806352	229 Count	778 Count	194 Count
1762804551	228 Count	772 Count	194 Count
1762802751	227 Count	770 Count	194 Count
1762800951	224 Count	765 Count	192 Count
1762799150	208 Count	728 Count	177 Count
1762797355	202 Count	718 Count	172 Count
1762795554	196 Count	707 Count	167 Count
1762793754	189 Count	692 Count	161 Count
1762791953	176 Count	669 Count	149 Count
1762790153	163 Count	648 Count	137 Count
1762788352	156 Count	635 Count	131 Count
1762786551	151 Count	625 Count	127 Count
1762784751	147 Count	621 Count	124 Count
1762782950	142 Count	613 Count	120 Count
1762781149	135 Count	604 Count	114 Count
1762779349	128 Count	591 Count	108 Count
1762777548	119 Count	579 Count	100 Count
1762775754	116 Count	569 Count	98 Count
1762773954	106 Count	549 Count	89 Count
1762772153	101 Count	533 Count	85 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)