EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

EA8EE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA8EE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1754247311	440 Count	330 Count	330 Count
1754245507	436 Count	327 Count	327 Count
1754243704	432 Count	324 Count	324 Count
1754241901	428 Count	321 Count	321 Count
1754240098	424 Count	318 Count	318 Count
1754238331	420 Count	315 Count	315 Count
1754236528	416 Count	312 Count	312 Count
1754234725	412 Count	309 Count	309 Count
1754232921	408 Count	306 Count	306 Count
1754231118	404 Count	303 Count	303 Count
1754229315	400 Count	300 Count	300 Count
1754227512	396 Count	297 Count	297 Count
1754225709	392 Count	294 Count	294 Count
1754223906	388 Count	291 Count	291 Count
1754222103	384 Count	288 Count	288 Count
1754220300	380 Count	285 Count	285 Count
1754218497	376 Count	282 Count	282 Count
1754216729	372 Count	279 Count	279 Count
1754214926	368 Count	276 Count	276 Count
1754213123	364 Count	273 Count	273 Count
1754211320	360 Count	270 Count	270 Count
1754209517	356 Count	267 Count	267 Count
1754207713	352 Count	264 Count	264 Count
1754205910	348 Count	261 Count	261 Count
1754204107	344 Count	258 Count	258 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)