EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2JP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2JP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1791455923	73 Count	381 Count
1791454242	67 Count	353 Count
1791452562	61 Count	325 Count
1791450881	57 Count	302 Count
1791449200	52 Count	276 Count
1791447519	46 Count	245 Count
1791445838	40 Count	223 Count
1791444157	34 Count	204 Count
1791442476	29 Count	176 Count
1791440796	24 Count	147 Count
1791439115	17 Count	109 Count
1791437435	13 Count	72 Count
1791425921	222 Count	854 Count
1791424240	216 Count	827 Count
1791422559	210 Count	805 Count
1791420876	201 Count	778 Count
1791419195	196 Count	753 Count
1791417514	190 Count	725 Count
1791415833	183 Count	698 Count
1791412722	170 Count	647 Count
1791411041	161 Count	614 Count
1791409360	145 Count	572 Count
1791407680	130 Count	531 Count
1791405999	124 Count	493 Count
1791404318	118 Count	451 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)