EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2WH-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2WH-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765860103	580 Count	800 Count	532 Count
1765858303	568 Count	781 Count	521 Count
1765856502	554 Count	762 Count	508 Count
1765854701	541 Count	741 Count	496 Count
1765852901	524 Count	716 Count	480 Count
1765851100	508 Count	694 Count	465 Count
1765849300	496 Count	675 Count	454 Count
1765847499	485 Count	660 Count	444 Count
1765845698	473 Count	643 Count	433 Count
1765843898	461 Count	624 Count	422 Count
1765842097	451 Count	609 Count	413 Count
1765840296	436 Count	585 Count	399 Count
1765838496	424 Count	565 Count	388 Count
1765836695	412 Count	548 Count	377 Count
1765834895	400 Count	532 Count	366 Count
1765833094	388 Count	515 Count	355 Count
1765831293	372 Count	491 Count	340 Count
1765829493	357 Count	471 Count	326 Count
1765827692	343 Count	453 Count	313 Count
1765825891	329 Count	434 Count	300 Count
1765824091	319 Count	417 Count	291 Count
1765822290	294 Count	391 Count	272 Count
1765820489	275 Count	368 Count	254 Count
1765818689	263 Count	352 Count	243 Count
1765816888	248 Count	332 Count	229 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)