EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2CA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2CA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1762814893	347 Count	958 Count	274 Count
1762813213	340 Count	936 Count	268 Count
1762811532	335 Count	913 Count	264 Count
1762809851	330 Count	891 Count	260 Count
1762808170	326 Count	865 Count	257 Count
1762806489	321 Count	846 Count	253 Count
1762804809	309 Count	823 Count	248 Count
1762803377	301 Count	805 Count	244 Count
1762801696	295 Count	788 Count	239 Count
1762800015	288 Count	772 Count	233 Count
1762798334	282 Count	754 Count	228 Count
1762796654	276 Count	735 Count	223 Count
1762794973	271 Count	721 Count	219 Count
1762793292	265 Count	700 Count	214 Count
1762791611	261 Count	678 Count	211 Count
1762789931	256 Count	661 Count	207 Count
1762788250	252 Count	642 Count	204 Count
1762786569	247 Count	624 Count	200 Count
1762784888	242 Count	608 Count	196 Count
1762783207	235 Count	594 Count	191 Count
1762781776	226 Count	577 Count	186 Count
1762780095	220 Count	563 Count	181 Count
1762778414	213 Count	547 Count	175 Count
1762776734	207 Count	532 Count	170 Count
1762775053	199 Count	515 Count	163 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)