EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2DTW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2DTW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1791452879	76 Count	779 Count	47 Count
1791451198	73 Count	750 Count	45 Count
1791449517	69 Count	718 Count	42 Count
1791447837	66 Count	691 Count	40 Count
1791446405	60 Count	664 Count	39 Count
1791444724	57 Count	640 Count	37 Count
1791443043	51 Count	612 Count	32 Count
1791441363	47 Count	574 Count	29 Count
1791439682	44 Count	538 Count	27 Count
1791438001	41 Count	491 Count	25 Count
1791436320	34 Count	429 Count	19 Count
1791434639	31 Count	386 Count	17 Count
1791432959	29 Count	345 Count	16 Count
1791431278	26 Count	312 Count	14 Count
1791429597	23 Count	276 Count	12 Count
1791427916	20 Count	236 Count	10 Count
1791426236	18 Count	199 Count	9 Count
1791424804	11 Count	172 Count	7 Count
1791423123	8 Count	138 Count	5 Count
1791421442	5 Count	101 Count	3 Count
1791419761	3 Count	65 Count	2 Count
1791418081	1 Count	32 Count	1 Count
1791416400	107 Count	1029 Count	69 Count
1791414719	103 Count	992 Count	66 Count
1791413038	100 Count	955 Count	64 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)