EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

S51ZK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object S51ZK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1762802268	107 Count	501 Count	99 Count
1762798665	95 Count	443 Count	88 Count
1762795061	73 Count	352 Count	67 Count
1762791477	58 Count	288 Count	53 Count
1762787874	45 Count	242 Count	41 Count
1762784271	35 Count	188 Count	32 Count
1762780668	25 Count	134 Count	23 Count
1762777064	14 Count	76 Count	13 Count
1762773461	0 Count	0 Count	0 Count
1762769876	145 Count	950 Count	134 Count
1762766273	128 Count	860 Count	118 Count
1762762670	118 Count	791 Count	109 Count
1762759067	106 Count	723 Count	98 Count
1762755464	95 Count	663 Count	88 Count
1762751860	80 Count	502 Count	74 Count
1762748276	63 Count	425 Count	58 Count
1762744672	53 Count	372 Count	49 Count
1762741069	42 Count	306 Count	39 Count
1762737466	32 Count	241 Count	30 Count
1762733862	21 Count	170 Count	20 Count
1762730259	10 Count	83 Count	10 Count
1762726679	184 Count	1014 Count	170 Count
1762723076	173 Count	934 Count	160 Count
1762719472	165 Count	881 Count	153 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)