EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F4BQN-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4BQN-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1771566515	677 Count	620 Count	615 Count
1771565703	669 Count	613 Count	608 Count
1771564799	656 Count	601 Count	596 Count
1771563896	647 Count	593 Count	588 Count
1771562992	637 Count	583 Count	579 Count
1771562087	629 Count	576 Count	572 Count
1771561184	619 Count	567 Count	563 Count
1771560280	611 Count	560 Count	556 Count
1771559376	598 Count	548 Count	544 Count
1771558473	590 Count	541 Count	537 Count
1771557569	576 Count	528 Count	524 Count
1771556665	568 Count	521 Count	517 Count
1771555760	555 Count	509 Count	505 Count
1771554856	548 Count	503 Count	499 Count
1771553953	536 Count	492 Count	488 Count
1771553049	528 Count	485 Count	481 Count
1771552146	516 Count	474 Count	470 Count
1771551242	508 Count	467 Count	463 Count
1771550338	496 Count	456 Count	452 Count
1771549434	488 Count	449 Count	445 Count
1771548529	476 Count	438 Count	434 Count
1771547625	467 Count	429 Count	426 Count
1771546721	456 Count	419 Count	416 Count
1771545817	446 Count	410 Count	407 Count
1771544914	435 Count	400 Count	397 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)