EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

GM4ISM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object GM4ISM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1792762115	117 Count	771 Count	98 Count
1792760311	111 Count	736 Count	93 Count
1792758508	105 Count	699 Count	88 Count
1792754902	92 Count	634 Count	77 Count
1792753132	87 Count	610 Count	73 Count
1792751329	83 Count	570 Count	70 Count
1792749526	80 Count	544 Count	68 Count
1792747723	76 Count	523 Count	65 Count
1792745920	71 Count	462 Count	61 Count
1792744117	66 Count	420 Count	57 Count
1792742313	60 Count	385 Count	52 Count
1792740511	53 Count	341 Count	46 Count
1792738707	46 Count	294 Count	40 Count
1792736904	39 Count	266 Count	34 Count
1792735101	32 Count	242 Count	28 Count
1792733298	25 Count	200 Count	22 Count
1792731533	18 Count	138 Count	16 Count
1792729730	11 Count	90 Count	10 Count
1792727927	4 Count	43 Count	4 Count
1792726124	170 Count	1030 Count	148 Count
1792724321	162 Count	990 Count	141 Count
1792722518	155 Count	941 Count	135 Count
1792720714	148 Count	890 Count	129 Count
1792718911	140 Count	838 Count	122 Count
1792717108	133 Count	792 Count	116 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)