EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

UN7CFI-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object UN7CFI-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1791554324	234 Count	135 Count	124 Count
1791553420	232 Count	134 Count	123 Count
1791552517	230 Count	133 Count	122 Count
1791551613	228 Count	132 Count	121 Count
1791550709	226 Count	131 Count	120 Count
1791549805	224 Count	130 Count	119 Count
1791548902	222 Count	129 Count	118 Count
1791547998	220 Count	128 Count	117 Count
1791547094	218 Count	127 Count	116 Count
1791546190	216 Count	126 Count	115 Count
1791545287	212 Count	123 Count	112 Count
1791544383	210 Count	122 Count	111 Count
1791543479	208 Count	121 Count	110 Count
1791542662	206 Count	120 Count	109 Count
1791541758	204 Count	119 Count	108 Count
1791540854	202 Count	118 Count	107 Count
1791539951	200 Count	117 Count	106 Count
1791539047	198 Count	116 Count	105 Count
1791538143	196 Count	115 Count	104 Count
1791537239	194 Count	114 Count	103 Count
1791536336	192 Count	113 Count	102 Count
1791535432	190 Count	112 Count	101 Count
1791534528	188 Count	111 Count	100 Count
1791533624	186 Count	110 Count	99 Count
1791532721	184 Count	109 Count	98 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)